The high speed machining center of much axle control

Add high to be being had in plane, turbine, hydraulic turbine and of all kinds mould before the complex form of value 0, use much talk working procedure and much stage machine tool to undertake machining. Such having machine cycle to grow only, because be installed for many times,still be placed and achieve high accuracy hard. Nevertheless, the technology is in ceaselessly progress. After list price rolls out machining center, can be opposite in holding clip 5 faces of preform have a variety of treatment such as planar, curved surface, bore and aperture of bore with a reamer, shortened thereby treatment cycle and rose to machine precision. Want the process capability of farther patulous machining center and treatment efficiency now, promoted machining center for this to much axle control and freeboard fast treatment way develops, your machine treatment is crossed ahead again into one stride.

Much axle control

Realize basic idea

The much axle control that says normally is the control that points to 4 axes above, have among them representative is machining center of 5 axle control. This kind of machining center can process the complex form work that cannot process with machine tool of 3 axle control. If use it to process the work that machine tool of 3 axle control can process, that can improve treatment precision and efficiency.

To the relative position of cutting tool and workpiece, machining center of present much axle control can install 6 axes, 3 axes of the X that the edge makes around, left and right sides point-blank or moves up and down namely, Y, Z, the B axis that still control workbench banking angle is spent and the C axis that command point of view of main shaft circumgyrate. When use circumgyrate cutting tool, make fluctuation or around shift by main shaft of revolving of Z axle control, make 5 axle control. Only use blame can make 6 axle control when circumgyrate cutting tool.

Machine efficiency to rise normally and use circumgyrate cutting tool, but also get consequently the limitation of circumgyrate cutting tool, put in the place that machines impossibly and appearance. Can use circumgyrate cutting tool not only now, still can use blame circumgyrate cutting tool and control its answer corner to spend, can machine to any appearance so, have with the treatment that is not circumgyrate cutting tool commonly dig is cut and the way such as flowing treatment is made on XY plane. The 6 axle control that had developed a kind to be able to use the cutting tool after improving to form unifinication now are compound type is new-style machining center.

The treatment characteristic of machining center of many 5 axle control

As a result of 5 axes the cutting tool of machining center can show aleatoric pose to undertake machining to workpiece, can avoid cutting speed to be the phenomenon of 0 so, still can choose optimum cutting tool to reach undertake effectively machining at the attitude of workpiece relatively, and right sunken the attitude that the appearance that enter tilts with cutting tool undertakes machining, these are the conditions that are helpful for treatment.
Previous12 Next